Construction method of yarn wall covering, non-woven fabric and woven wall covering

Yarn wall covering, non-woven fabric, woven wall covering construction method: 1. Since the wall covering itself absorbs water, the glue preparation should be thick to reduce the flow. Appropriate amount of white glue should also be added to the glue to increase adhesion, and glue directly on the wall. 2. Do not use hard boards or nylon brushes. Use a soft brush to gently scrape from top to bottom to paste the wallpaper on the wall. 3. Keep your hands clean, apply glue carefully, and don't pollute the wall cloth surface. 4. Before pasting, you should use double-sided tape to paste a section off the edge of the wall cloth, and increase the width of the wall cloth to prevent the edge of the wall cloth from being contaminated by glue. 5. In case the wall cloth surface is contaminated, only one unit of the contaminated area can be cut according to the width. 6. Use a brush to gently drive out the bubbles. Don't use too much force to avoid damaging the fabric of the wall covering, especially when the wall covering is pasted with yarn. Pay special attention to the air bubbles near the joints. 7. Avoid overlapping cut wall coverings at the internal corners, and not cutting wall coverings at the external corners, so as not to cause the edge of the wall coverings at the external corners. 8. If there is dust on the surface, apply a soft brush or duster to flick it. Do not wipe with a wet towel to cause the stain to expand. 1. Since the wall covering itself absorbs water, the glue should be thickened to reduce the flow. Appropriate amount of white glue should also be added to the glue to increase adhesion, and glue directly on the wall. 2. Do not use hard boards or nylon brushes. Use a soft brush to gently scrape from top to bottom to paste the wallpaper on the wall. 3. Keep your hands clean, apply glue carefully, and don't pollute the wall cloth surface. 4. Before pasting, you should use double-sided tape to paste a section off the edge of the wall cloth, and increase the width of the wall cloth to prevent the edge of the wall cloth from being contaminated by glue