Detailed tutorial of practical storage basket made of non-woven fabric, with a woven display

By cutting the non-woven fabric into elongated strips and simply knitting by hand, it is possible to easily make a multifunctional non-woven fabric storage basket, which is a storage container for keys, jewelry, cosmetics, sewing, etc. Material: gray hard non-woven fabric, white adhesive non-woven fabric, clip, nylon thread, iron, scissors, needle thread or glue. 1. The finished size of the woven basket is 14*14*10cm, and 19 pieces of hard non-woven fabrics 2*50~57cm long are cut. 2. Fix the fixing clip between adjacent strips. Use the fixing clips at both ends of the strap to tightly arrange the 7 straps 3. The other strap should be woven horizontally between the 7 parallel straps, and then the other strap should be woven horizontally 4. Fix the straps on the braided straps in place with clips 5. Follow step 3 to continue knitting until you knit 7 strips so that the bottom of the basket has been woven. 6. Take a long strip and connect the two ends into a loop, which can be connected with needle, thread, glue or stapler 7. Use the same method to connect the other four strips to form a loop 8. Start weaving the sides of the basket, weave a round strip next to the central strip, and fix the position with a clip 9. Weave the connected sides into a loop, Until all four connected sides are looped 10. Use fixing clips for positioning 11. Weave the second round strip in the same way as in steps 6-7 12. Until all 5 round strips are knitted 13. Cut off the excess length around the edges, leaving an end about 4 cm long. 14. Begin to close the top edge of the basket, alternately fold the ends of the strips, and fix them with clips 15. Insert the folded outer end into the inside of the first ring 16. As shown in step 11, fold all the outer ends to the inside of the strap to hide them. 17. Then fold the inner end outwards and insert the ends into the inner side of the second ring below. 18. Hide both ends as well. 19. Put nylon The thread is threaded into the outer braid on the top edge and a knot is tied on the outside of the rope 20. Use a printer to print the label 21. Cut out a piece of non-woven fabric slightly larger than the white label. Put the label pattern down on the non-woven fabric and iron the label paper with iron 22. When the pattern on the printing paper is printed on the non-woven fabric, please carefully remove the white label paper 23. Cut off the extra blank area 24. From white Remove the back sticker from the non-woven fabric and paste it on the side of the storage basket. 25. Finally, install decorative hemispherical rivets on the four corners of the label and tie a bow in front of the rope to complete the storage basket. produce.