How to install non-woven wallpaper

Non-woven wallpaper is different from traditional wallpaper. The use of traditional pasting methods can easily cause pollution of non-woven wallpaper and reduce the service life of non-woven wallpaper. Therefore, there are different ways to paste non-woven fabrics. Next, let’s talk about it. Talk about the steps of pasting non-woven wallpaper: 　　1, check the cutting paper: 　　 check the product identification and read the construction instructions, it must be cut and used in the order of product batch number, box number, and roll number. Calculate the cutting paper length according to the height of the working wall. The pattern above the wallpaper should be a complete pattern, and the position should be appropriate. When cutting, compare the pattern with the previous product, the position is correct, the length is appropriate, and the direction mark is made at one end. When placing after cutting, you should enlarge the curvature as much as possible, and be careful not to cause crease marks and affect the decorative effect. 2. Gluing: 　　 non-woven paper wallpaper is different from other wallpapers because of its good air permeability and strong hygroscopicity. The glue should be thicker and thicker than other wallpapers to reduce its fluidity. The water content of the wallpaper glue should be reduced. Glue the surface evenly. Never brush the glue directly on the back of the non-woven fabric, let alone soak it in water and wet it. 3. Posting: 　　 Start pasting from the internal corner of the room, and measure it with an infrared level meter (to prevent the wallpaper from tilting because the internal corner is not straight). Use a brown brush to flatten the wallpaper and scrape out bubbles. Do not use hard tools such as scrapers to prevent surface fiber from fluffing. The front and back stickers'↑↓' products need to be pasted in the opposite direction, and each wallpaper should be tailored on the same side.　　4. Joint treatment: 　　 The joints can be compacted with a soft rubber roller. It is forbidden to overflow the joints to avoid affecting the product effect.　　5. Wide product construction: 　　Wide non-woven paper construction needs to be tailored on the wall, and the cutting edge should be kept sharp when trimming or lap tailoring to avoid affecting the joint effect. To keep the seams vertical, use a tailor's spatula or a steel ruler to prevent the seam from running straight. After trimming, take out the cut parts on both sides, and use a soft rubber roller to compact the joints to prevent glue overflow at the joints.　　Purchase non-woven products, Non-woven Co., Ltd. specializes in the production of various non-woven products. Friends from all walks of life are welcome to cooperate! Previous: What are the advantages of non-woven handbags compared to plastic bags?