Non-woven products construction method

Non-woven wallpaper, also called non-woven paper wallpaper, is a kind of wallpaper/wallpaper, because it is made of natural plant fiber non-woven technology to make it stronger, more environmentally friendly, not moldy and yellow, and good air permeability is the primary basis for high-quality wallpaper. material. Pasting method of non-woven wallpaper: 1. Wall surface treatment The wall surface should be flat, clean, and dry, with uniform colors, and there should be no gaps, uneven convexities and inequalities. The wall surface should be treated with a base film (or varnish) before construction. 2. Wallpaper cutting. Place the wallpaper according to the serial number of the wallpaper, measure the height of the wall, and cut the wallpaper by setting aside 5 cm above and below the height of the wall. Remember to cut one roll of wallpaper at a time to prevent quality problems. 3. It is necessary to brush the wallpaper glue on the non-woven fabric wallpaper glue evenly on the wall, the thickness is only 2mm, never brush the glue directly on the reverse side of the non-woven fabric, let alone soak and wet it. Unlike other wallpapers, non-woven fabrics should have a thicker and thicker glue than other wallpapers to reduce their fluidity. 4. Pasting the wallpaper Post the non-woven wallpaper in the order of the prior comparison. 5. Construction wallpaper cutting requires side-to-side cutting construction. The specific method is to lay the side during construction. The amount of the side depends on the pattern, about 3 cm. The plain non-woven fabric should be pasted in front and back during construction. Construction method. After ensuring the alignment of the pattern, use a ruler to press the stack at the stacking place to cut, try to prevent cutting at the outside corner, avoid causing the wallpaper at the outside corner to warp, and ensure the cutting when cutting. The knife has a sharp point and no burrs. Pay attention to the strength of the knife. Make sure to cut once and make a decisive action, but you can't damage the surface of the wall excessively. 6. Clean after the wallpaper is pasted. If there is dust on the surface after construction, use a short-bristled brush or duster to wipe it, and do not scrub with a wet towel to cause pollution. Precautions for pasting non-woven wallpaper: 1. After the primer coating is dry during construction, draw a vertical line as a specification to avoid incorrect orientation of the wall paper. 2. Hard scrapers or nylon brushes cannot be used after the wallpaper is on the wall, but a soft brush should be used to gently scrape from top to bottom to smooth the surface of the non-woven fabric, remove bubbles and wrinkles, and do not scrape the glue out of the joints to avoid pollution If you accidentally squeeze out the glue, wipe it with a dry towel immediately, and try to keep your hands clean during construction. 3. During construction, check while constructing, stop the construction as soon as the problem is found, and find out the reason and solution before proceeding.