Non-woven wallpaper construction method and matters needing attention

Non-woven wallpaper, also called non-woven paper wallpaper, is a type of wallpaper/wallpaper. It is made of natural plant fiber non-woven technology to have stronger tensile force, more environmental protection, no moldy and yellowing, and good air permeability is the main basis of high-quality wallpaper. material.　　Non-woven wallpaper pasting method: 　　1, wall treatment　　The wall surface should be flat, clean, dry, uniform in color, and there should be no voids, unevenness of convexity and concave defects. The wall surface should be treated with base film (or varnish) before construction.　　2. Wallpaper cutting　　 Place the wallpaper according to the serial number of the wallpaper, measure the height of the wall, and reserve 5 centimeters above and below the height of the wall to cut the wallpaper. Remember to cut one roll of wallpaper at a time to prevent quality problems.　　3, brush wallpaper glue　　 paste non-woven wallpaper glue must be evenly painted on the wall, the thickness is only 2mm, never brush the glue directly on the back of the non-woven fabric, let alone soaking wet paste. Unlike other wallpapers, non-woven fabrics should have a thicker and thicker glue than other wallpapers to reduce their fluidity.　　4. Paste the wallpaper　　 Post the non-woven wallpaper in the order compared in advance. 5. The cutting of construction wallpaper requires side-to-side cutting construction. The specific method is to lay the sides during construction. The number of sides depends on the pattern, about 3 cm. The plain non-woven fabric is pasted in front and back during construction. Method of construction. After ensuring that the pattern is aligned, use a ruler to press the overlapping area and cut it. Try to avoid cutting at the outside corner to avoid warping the wallpaper at the outside corner. Make sure to cut it when cutting. The knife should be sharp and should not have burrs. At the same time, pay attention to the strength of the knife. Make sure to cut and cut two pieces at a time, but it should not damage the surface of the wall excessively.　　6. u200bu200bClean after the wallpaper is pasted　　 If there is dust on the surface after construction, use a short-haired brush or duster to wipe it gently. Do not wipe it with a wet towel to cause the pollution to expand.　　Precautions for pasting non-woven wallpaper: 　　1, after the base paint coating is dry during construction, draw a vertical line as a standard to avoid incorrectly pasting the wallpaper. 2. Do not use a hard scraper or nylon brush after the wallpaper is on the wall. You should use a soft brush to gently scrape from top to bottom to smooth the surface of the non-woven fabric to remove bubbles and wrinkles. Do not scrape the glue out of the joints to avoid pollution If you accidentally squeeze the glue out of the surface, wipe it off with a dry towel immediately, and try to keep your hands clean during construction.　　3. During the construction, the construction should be inspected, and the construction should be stopped immediately if the problem is found, and the cause and solution should be found before construction.