Non-woven wallpaper paving 6 steps easily

There are many types of styles available for home decoration, but there are still many similar decoration styles among relatives and friends. So some people are not satisfied with this and want to be unique. Then the best solution is to make the wallpaper the highlight of your home. Whether the effect of wallpaper decoration is good, in addition to choosing beautiful patterns, special attention should be paid to its paving effect. Let’s teach you how to paste non-woven wallpaper.　　1. Wallpaper cutting　　 Place the wallpaper according to the serial number of the wallpaper, measure the height of the wall, and set aside 5 cm above and below the wall height to cut the wallpaper. Remember to cut one roll of wallpaper at a time to prevent quality problems.　　2, wall surface treatment　　The wall surface shall be smooth, clean, dry, uniform in color, and free of voids, unevenness of convexity and concave defects. The wall surface shall be treated with a base film (or varnish) before construction.　　3. Brush wallpaper glue 　　 paste non-woven wallpaper glue must be evenly painted on the wall, the thickness is only 2mm, never brush the glue directly on the back of the non-woven fabric, let alone soaking wet paste. Unlike other wallpapers, non-woven fabrics should have a thicker and thicker glue than other wallpapers to reduce their fluidity.　　4. Paste wallpaper　　 Post the non-woven wallpaper in the order of comparison. 5. The cutting of construction wallpaper requires side-to-side cutting construction. The specific method is to lay the sides during construction. The number of sides depends on the pattern, about 3 cm. The plain non-woven fabric is pasted in front and back during construction. Method of construction. After ensuring that the pattern is aligned, use a ruler to press the overlapping area to cut the pattern. Try to avoid cutting at the outside corner to avoid warping the wallpaper at the outside corner. Make sure to cut it when cutting. The knife should be sharp and should not have burrs. At the same time, pay attention to the strength of the knife. Make sure to cut and cut two pieces at a time, but not excessively damage the surface of the wall.　　6. u200bu200bClean after the wallpaper is pasted　　 If there is dust on the surface after construction, apply a short-haired brush or duster to wipe it gently, and not wipe it with a wet towel to cause the pollution to expand.