Reasons and solutions for non-woven fabrics easy to wet bags

Reasons for non-woven wet pack


First: The instrument is not thoroughly cleaned and dried, and there is water before packaging.


Second: The steam humidity of the sterilizer is too high.


Third: The drying time is insufficient after sterilization.


Fourth: Take out the sterilization package immediately after the sterilizer is turned on, and there is no condensate generated when the sterilization package is cooled and then taken out.


The easy-to-wet non-woven fabric is a common problem in the department, so under the same conditions, the root of the non-woven easy-to-wet bag lies in:


The surface tension of non-woven fabrics is different from that of cotton and crepe paper, which makes it easier for water vapor to form water droplets on the surface of non-woven fabrics (especially the contact between metal and non-woven fabrics). The beads are scattered and do not coagulate easily. The more the water is dispersed, the larger the specific surface area of u200bu200bthe water, the faster the evaporation rate, and the less the wet pack phenomenon.


Solution


1. Increase steam saturation and adjust traps.


2. Appropriately reduce the load in the sterilizer, leaving a gap between the packages.


3. Properly extend the drying time.


4. Put absorbent material in the large equipment bag.


5. After the sterilization, open the door 20cm and let it dry for 30 minutes.